Page 2
Meet PAT™
| Products and Things Pty Ltd |
meetpat.com.au
| Level 1, 419 Townsend Street, Albury, NSW, 2640, Australia
Phone: (02) 60217813, +61260217813 Email: [email protected]
Meet PAT™
| Meet PAT Limited NZ |
meetpat.co.nz
| 12 Bethlehem Road, Bethlehem, Tauranga, 3100
Disclaimer and Safety
Here at Meet PAT™ we are very safety conscious. We design and manufacture water
related products with the safety of you, the user, foremost in mind. In addition, we
ask that you exercise a degree of care when using any Meet PAT™ product.
IMPORTANT SAFEGUARDS FOR YOUR MEET PAT UNITS
•
Carefully read all instructions before operation and save them for future reference.
•
Find a suitable location for setting up the units.
•
Do not set the units up near live exposed electrical connections or wiring.
•
Check the quality and potability of the water source and that there is correct pressure.
•
Set up all connections before turning on the water supply.
•
Once the water supply is turned on check each unit’s connections for leakages. If a
leakage is found turn off the water supply and remove the pressure from the units by
pressing the refill buttons. Unplug the leaking connection and check for damage or dirt.
Do not use if any leaks are prevalent.
•
Units can be heavy to install, use the appropriate number of people and equipment.
•
Ensure the units are regularly cleaned and serviced.
• If applicable, ensure the water filters are replaced as required.
Meet PAT™ takes no responsibility for suitability of install location, clearance for traffic, pedestrians or
other clearance requirements. Meet PAT™ recommends that the chosen locations are reviewed for OHS
and suitable other parties (including council) to ensure compliance. Meet PAT™ takes no responsibility for
the structural integrity of the mounting surface chosen and recommends consultation with an engineer or
suitable other parties prior to mounting.
For individual material, component or further installation details, please contact Meet PAT™ sales. Meet
PAT units have a maximum working pressure of 6 bar - 600kpa (87 psi/ 0.6MPa). Customer or installer to
check pressure and install pressure relief valve on supply side if required.
Meet PAT™ products must be installed in accordance with the provisions of AS/NZS3500 and any
relevant local regulations. Installations not complying with AS/NZS3500 may void the product and
performance warranty provisions.
All recommendations within this document should be used as a guide only. Users and
installers should seek suitable assistance to ensure units comply with all standards and are
safe for use.
