Meec tools 024342, Руководство по эксплуатации

Страница: 47 / 90

EN
47
2. Screw together with the screws M8x20
mm (C), M8x25 mm(D), spring washers
Ø8 (B) and washers Ø8 (A). (Assembly
parts A, B, C, D are in bag G.)
FIG. 14
POSITIONING THE CONCRETE MIXER
The concrete mixer should be placed on a
smooth and level surface. To ensure stability the
product should be anchored to a concrete floor
with screws, plugs and washers (sold separately).
1. Choose a place where the product can be
placed permanently. Check that there is a
suitable power point nearby.
2. Mark out two holes to position the
product (7c).
FIG. 15
3. Drill the two holes.
4. Remove any dust and insert plugs. Check
that the edges of the holes are smooth.
5. Fix the product in place with washers and
screws (sold separately), recommended
size M10.
WARNING!
Do not put anything under the product to adjust
the height or improve its stability. If the product
is not level or stable, move it to another place.
Do not attempt to use the product on grass or
gravel – it can sink and/or tip over and cause
personal injury and/or material damage.
USE
BEFORE USING
Always check that the product is in good
condition before use. Check that all screw
unions are tight, that moving parts are
correctly adjusted and can move freely, that no
parts are incorrectly fitted or broken, that no
wires or belts are damaged, and that there are
no other factors that could affect functionality.
MAINS CONNECTION
1. Keep the work area clean and well lit.
Keep children, onlookers and pets away
from the work area. You can easily lose
control of the product if you are distracted
– risk of personal injury.
2. Route the power cord so that there is
no risk of tripping over or damaging it.
The cord must be long enough to ensure
freedom of movement when working.
3. Because the product uses water the power
cord should be hung in a curve below the
power point to ensure that water cannot
run along the cord to the power point.
WARNING!
• Check that the mains voltage corresponds
to the rated voltage on the type plate.
• Only use an extension cord approved for
outdoor use. Connect the cord to a
splash-proof power point.
• The cross-sectional area of the extension
cord must be dimensioned for the power
supply to the product.
- 1.5 mm2 up to 60 m in length
- 2.5 mm2 up to 100 m in length
• Use a mains connection protected by a
residual current device. Check that the
circuit is not overloaded.
ADJUSTING
1. Adjust the angle of the drum by pulling
out the control wheel (9). First release
the lock pin by pulling the control wheel
away from the drum and then turning the
wheel until the drum is at the required
angle. Move back the wheel so that the
lock pin engages again.
1. Mortar
2. Concrete
3. Emptying
4. Storage
FIG. 16
WARNING!
• Switch off the product and pull out the
plug before adjusting.
• Keep a firm grip on the control wheel
when turning it.