Meec tools 017978, Руководство по эксплуатации, Страница: 23 / 48

EN
23
• Always replace both planing bits at the
same time to avoid imbalance and
vibration, which will reduce the life span
of the product.
• Always wear ear protection and, depending
on the type of job, also a dust filter mask/
face mask, gloves, helmet or apron.
• Keep the front bottom halves as close
together as permitted by the work.
• The part of the planing bit not in contact
with the workpiece should be covered.
• Use the shavings outlet cover.
MINIMISATION OF NOISE AND
VIBRATION
• Plan the work so that exposure to heavy
vibrations is spread over a longer period.
• To reduce noise and vibrations when in
use, limit the time the tool is in use, and
use low-power/vibration mode and
suitable safety equipment.
• Take the following precautions to
minimise the risks of exposure to
vibrations and/or noise:
– Only use the tool in accordance with
these instructions.
– Check that the tool is in good
condition.
– Use accessories in good condition,
and which are suitable for the
purpose.
– Keep a firm grip on the handles/
grips.
– Maintain and lubricate the tool in
accordance with these instructions.
• Secure the workpiece on a stable surface
with clamps, or the like. Holding the
workpiece in your hand or against your
body will not give you a sufficiently firm
grip and can cause you to loose control.
• Do not allow familiarity with similar
products to lead to exaggerated
self-confidence and to neglect the safety
instructions for the product. Failure to
follow all the instructions and safety
instructions can result in the risk of serious
personal injury.
• Keep the work area free from rags, loose
clothing, and string, etc.
• Do not allow the cutting edge to come into
contact with nails. Check the workpiece and
remove any nails before planing.
• Only use sharp planing bits. Handle
planing bits with care.
• Check the condition of the planing bits
and that all the screw unions are properly
tightened.
• Hold the tool firmly with both hands.
• Always keep your hands at a safe distance
from rotating parts.
• Allow the product to run with no load a
little before use. If the product vibrates
abnormally this can be because the
planing bits are incorrectly mounted or
poorly balanced.
• Check that no cutting edges are touching
the workpiece when starting the product.
• Allow the product to reach maximum
speed before it makes contact with the
workpiece.
• Switch off the product, pull out the plug,
and wait until all moving parts have
completely stopped before cleaning,
maintenance and/or replacing/adjusting
accessories.
• Never put your fingers or other parts of
the body in the outlet for shavings. The
outlet can become blocked when working
with damp wood. In which case, clear the
outlet with a stick. Only run the product
when holding it.