EN
23
TROUBLESHOOTING CHART
Problem
Possible cause
Proposed action
The product will not
start.
No power supply.
Check the power supply.
The float switch has not tripped. Lift up the float switch.
No flow of water.
The inlet is blocked.
Clear the inlet.
The outlet hose is clinched.
Adjust the hose.
The product does not
stop.
The float switch cannot sink far
enough.
Place the product correctly on a level
surface on the bottom of the well.
Too little water flow.
The inlet is blocked.
Clear the inlet.
Parts are worn as a result of
contaminants.
Clean the pump and replace worn
parts.
The product starts, but
soon stops.
Contaminants in the water
can cause the overheating
protection to trip and stop the
motor.
Disconnect the power supply and
clean the pump.
Hot water can cause the
overheating protection to trip
and stop the motor.
Make sure that the temperature of
the pumped water is no more than
35°C.
MAINTENANCE
CLEANING
Clean the outside of the product. Rinse with
clean water. Remove stubborn stains with a
brush and detergent. Lower the product into a
container with clean water and run for a short
time to flush the inside of the product.
NOTE:
Clean the product after it has not been used
for some time to prevent any deposits or
contaminants causing a blockage.
STORAGE
If there is a risk of frost, dismantle and clean
the product and its accessories and store in a
frost-free place.
NOTE:
Risk of material damage. The product and its
accessories contain water, which means that
they can burst if the water freezes.
Содержание 015279
Страница 4: ...1 A B ...
Страница 44: ......
