Meec tools 015279, Руководство по эксплуатации

Страница: 22 / 44

EN
22
HOW TO USE
NOTE:
When used hanging on the line: Do not
run the product without the outlet tube
connected. Make sure the product does
not turn around its longitudinal axis.
If the product is used hanging from the line,
the line must be checked at regular intervals
for wear and damage.
AUTOMATIC MODE
The water pump can be unattended when
working under automatic mode. When the
water level reaches the "ON" switch, the
pump starts pumping. When the water level is
lower than the "0FF" switch, the pump stops
pumping, and circulates in turn.
1. Set the "ON" switch for the water level
to the "Auto" range (B) and adjust the
positions of the "ON" and "OFF" switches
according to the actual needs.
2. Plug the power cord plug in.
FIG. 1
MANUAL MODE
1. Set the "ON" switch for the water level to
the "Manual" position (position A).
2. Plug the power cord plug in.
TIPS
If the power cord plug of the pump has been
plugged in and the pump is transferred from
the automatic mode to the manual mode, the
"ON" switch for the water level can be directly
adjusted to the "Manual" position without
pulling out the plug.
– When using a hose, screw a suitable
hose adapter on the outlet
connection.
2. Press the hose firmly on the hose adapter
and secure with a hose clip.
– A suitable hose can be used for
temporary use. For permanent
installation a tube and non-return
valve are recommended to prevent
return flow when the product is
switched off.
3. Fasten a suitable line to the handle and
lower the product at an angle into the
water, so that no air remains underneath
the product – this prevents suction.
Once the product is submerged,
it can be straightened up.
4. Place the product on the bottom of the
tank. Fasten the end of the line securely
when the product is lowered down.
The product can also be used suspended
from the line.
5. The product is ready to use when it is
connected to the power supply.
NOTE:
• The product needs a free space of at
least 60 x 60 cm. The maximum
submersion depth is indicated in the
technical data.
• Install the product so that the intake
opening cannot be blocked.
LEVEL ADJUSTMENT
The start level is controlled automatically by
a sensor, placed in a connection on the pump
casing. The sensor is connected to the pump
housing. Check before starting that the metal
surface of the sensor is clean and fully exposed.
NOTE:
If the sensor is not correctly connected to the
pump casing there is a risk that the product
will not start at the specified level, or that it
will run dry, which will damage the product.