EN
21
1. Adjust the position of the float switch
so that the water level is controlled
automatically. The gap between the top
of the float switch and float line adjuster
must not be too small, otherwise the float
switch will not work properly.
2. Make sure that the float switch does not
reach the bottom before the pump stops.
WARNING: Risk of running dry.
NOTE:
• Risk of material damage. Do not lift the
product by the cord or the outlet tube,
they are not designed to support the
weight of the product. The float switch
must be able to move so that the
product cannot run dry.
• When used hanging on the line: Do not
run the product without the outlet tube
connected. Make sure the product does
not turn around its longitudinal axis.
If the product is used hanging from the
line, the line must be checked at regular
intervals for wear and damage.
• Risk of material damage. The specified
particle size refers to soft particles of
various sizes. The product must not be
exposed to sand or stones.
• Do not use the product to transport
corrosive, flammable or explosive
substances such as petrol or other
petroleum products, nitrogenous liquids,
grease, oil, salt water or waste water
from toilets, or liquid that has a higher
viscosity than water.
• The temperature of the pumped water
must not exceed 35°C.
MAINTENANCE
CLEANING
Clean the outside of the product. Rinse with
clean water. Remove stubborn stains with a
brush and detergent. Lower the product into a
– A suitable hose can be used for
temporary use. For permanent
installation a tube and non-return
valve are recommended to prevent
return flow when the product is
switched off.
3. Fasten a suitable line to the handle and
lower the product at an angle into the
water, so that no air remains underneath
the product – this prevents suction.
Once the product is submerged,
it can be straightened up.
4. Place the product on the bottom of the
tank. Fasten the end of the line securely
when the product is lowered down.
The product can also be used suspended
from the line.
5. The product is ready to use when it is
connected to the power supply.
NOTE:
• The product needs a free space of at
least 60 x 60 cm. The maximum
submersion depth is indicated in the
technical data.
• Install the product so that the intake
opening cannot be blocked.
LEVEL ADJUSTMENT
The product must have a float switch that
starts and stops the pump automatically.
The float switch must be fastened so that it
can float freely and start and stop the product.
The float switch can be set variably by undoing
the screws and adjusting the free length of the
cord.
FUNCTION CHECK BEFORE
STARTING
Check the function of the float switch by
carefully lifting it up and lowering it down to
check that it closes and switches correctly.
