Meec tools 010974, Руководство по эксплуатации

Страница: 16 / 16

EN
16
manually, so that diagonal lines can be
projected.
FIG. 4
1. Place the product on a flat surface or
fit it on the fastener as described in the
instructions in section 5.2.
2. Start the product by moving the power
switch (1) to the left (seen from the front
of the product).
3. Wait until the automatic levelling is
completed and then move the power
switch (1) back to the right.
4. Now press the button (5). The laser units
go on and the status light (4) goes red,
because the pendulum is locked.
5. The product can now be tilted to the
required angle so that the lines are
projected on the wall, see fig. 5.
6. Press the button (5) again to hide or
show the vertical and horizontal lines
separately, or to switch off the product.
MAINTENANCE
CLEANING
Use a soft cloth moistened with water and a
mild detergent.
NOTE:
• Switch off the distance meter before
cleaning.
• Make sure that no water gets into the
product.
• Do not use abrasive or strong detergent/
solvent, they can damage the plastic
parts.
STORAGE
Store the product and accessories in the
original pack, in a dark, dry, frost-free place,
out of the reach of children.
2. Start the product by moving the power
switch to the left (seen from the front
of the product). The laser goes on, the
green status light (4) goes on, and the
pendulum is released, so that the laser
can be levelled.
3. Press the button (5) to show or hide the
vertical and horizontal lines separately.
FIG. 1
Switching off
Switch off the product by moving the power
switch to the right (seen from the front of the
product). The laser goes off and the pendulum
is locked.
FIG. 1
IMPORTANT:
The product must be switched off and locked
according to the instructions above when
transported, otherwise it could be damaged.
AUTOMATIC LEVELLING
When the product is started with the
power switch (1) the laser units are levelled
automatically with the pendulum, so that the
lines are projected horizontally (360°) and
vertically on the wall, see figure. Press the
button (5) to show or hide the vertical and
horizontal lines separately.
FIG. 3
IMPORTANT:
Make sure that the product is not tilted more
than 4 degrees or at an angle. If this happens
the laser beams start to flash and a red status
light (4) goes on.
MANUAL LEVELLING
The laser beam units can also be levelled