8
USING AS A WIRED HEADPHONE
The Wave can be used as a wired headphone by plugging one end of the
included stereo audio cable into the jack on the left earcup and the other end
into any audio device with a standard 3.5mm headphone jack. This allows
use when the battery is depleted and with devices that do not have Bluetooth
(such in-flight entertainment systems) or aren’t paired.
The Wave can be used wired while also connected via Bluetooth to another
device; Bluetooth audio takes precedence over wired audio. Wired audio will
be partially muted whenever a signal is transmitted via Bluetooth and will
resume approximately 4 seconds after the Bluetooth transmission ends.
Note: The built-in microphone of the Wave will not work in wired mode.
SAFETY AND CARE
When not in use, power the headphones off and store in the included
protective carrying pouch.
Clean with a soft cloth, damp with diluted soap water solution if
necessary. Do not use chemical cleaners.
There are no user replaceable/reparable parts in the headphones.
Disassembling the device will void your warranty.
Do not expose the headphones to liquids. If the device comes in
contact with liquids, quickly wipe away. If submersed in water, do not
turn the device on until completely dried. Note: liquid submersion voids
the warranty.
Do not use around flammable gasses as fire or explosion may occur
Battery performance will be severely decreased when stored in extreme
temperatures: below -10°C/14°F or above 45°C/113°F including direct
sunlight.
Replacement parts and accessories are available online at
www.MEEaudio.com
a)
b)
c)
d)
e)
f)
g)