Medrad Mark 7 Arterion, Руководство по эксплуатации

Страница: 64 / 162

MEDRAD
®
Mark 7 Arterion Injection System
10 - 56
Figure 10 - 3: Twist & Go Connection
3.
Turn the (A) Luer nut clockwise to securely tighten the high pressure connector tubing to the
syringe tip (B).
4.
Purge all air from the high pressure connector tubing. Turn the Manual Knob clockwise to
push contrast out until all of the air bubbles have been removed from the High Pressure
Connector Tube. Gentle tapping at any connection point may be needed to facilitate air
removal.
10.5 Installing the MEDRAD
®
VFlow Hand Controller
1.
Ensure that the injector is in the disarmed state.
2.
Open the hand controller bag using sterile technique.
3.
Using sterile technique, remove the hand controller from the bag.
4.
Plug the hand controller into the underside of the Injector Head (see drawing below). Listen
for an audible “click” to confirm proper connection.
Figure 10 - 4: Hand Controller Connector
NOTE:
If the hand controller is damaged or does not work properly, discontinue use and
discard.