Medline Patient Lift, Руководство пользователя

Страница: 3 / 10

Assembly
The following tools are required for assembly:
One hex wrench with a 17mm side and a 19mm side.
1. Carefully unpack Medline Industries, Inc. Lifter,
swivel bar/6 point cradle and adjusting lever handle.
Check all parts for shipping damages before using
2. Insert mast in base sleeve (Figure 1). Be sure notch
on end of mast fits over bolt in bottom of mast sleeve.
Mast must lock into position in base sleeve, making it
impossible to rotate. Double check to be sure mast
cannot rotate.
3. Make certain boom points in the same direction as
base legs. Thread mast safety lock and stud into
threaded hole in mast sleeve. Tighten firmly, locking
mast into base (Figure 2). Keep mast and base
locked at all times except when removing mast from
base for storage.
-Warning-
Be sure the bolt is aligned correctly and fully
engaged or failure may result. Worn parts could fail,
resulting in injury to resident/caregiver.
4. Insert boom end into hole in yoke hinge at the top of
mast. Fasten bolt and nut (Figure 3). Be certain hex
of bolt head fits into formed hex on side of hinged
and that plastic washer is under lock nut.
5. Attach hydraulic pump to boom (Figure 4a & 4b).
Figure 1
Figure 2
Figure 3
Figure 4a
Figure 4b