9
Brake Handle Assembly
1.
Insert hand grip into appropriate hole
(see Figure A and chart below).
Note:
Keep brake cable on outside of rollator.
2.
Insert triangular hand screw into hole on outside of rollator frame
(see Figure
B). (Important: Insert hand screw into one of the 4 holes provided. DO
NOT put hand screw in open slot at end of hand grip!)
3.
Hand tighten screw until secure
(see Figure C)
.
(Important: Hand Tighten
Only!)
4.
Repeat steps 1-4 for other hand grip.
Rollator Hole Measurements: Arm Height
Figure A
Figure B
Figure C
Figure D
Leg Height
Seat height adjustable from 18
” to 23" (45.72 to 58.42 cm)
Handle height adjustable from 29" to 36" (73.66 to 91.44 cm)
To determine proper height
, stand upright behind the rollator with
shoulders relaxed, arms hanging at your side and eyes looking
straight ahead. Standing in current position, the hand grips (A) of the
rollator should be adjusted to a height even with the wrists. This will
position the arms at an approximated 20 to 30 degree bend when
using the rollator. Secure the wheels to the closest hole to the desired
height. Insert and tighten the triangular hand screws until secure.
(Important: Hand Tighten Only!)
