Operating Instructions for the Actineb MEDIX Nebuliser System
Introduction
This nebuliser system is designed to deliver a fine aerosol mist from the liquid medication prescribed
by your doctor to treat your respiratory condition. Use according to the instructions given by your
doctor or physician. Please read the instructions carefully to obtain the maximum benefit from this
nebuliser system. Please read these instructions before using the equipment
Page 1:
This mains only nebuliser system has been designed to operate from 230V ~ 50Hz (UK/EU versions,
model 3604700/3604701)
The Actineb is supplied with a kit consisting of:
1 x nebuliser chamber 1 x adult face mask
1 x driveline 1 x inlet filter disc
Operating Instructions
Mains AC Operation
1 Connect mains plug to mains power supply.
2 Connect driveline to outlet nozzle.
3 Connect nebuliser chamber, followed by face mask or
mouthpiece (optional extra), to the driveline. (see below)
4 Press mains switch on. The equipment will now operate.
Note:
Both versions are intermittently rated and are fitted with thermal cut-outs to protect the
equipment. They can be used for continuous treatment up to 1 hour. Do not re-use within 1 hour.
Caution:
Do not immerse in water.
Filling the Nebuliser Chamber
-
For Single Patient Use
1 Connect one end of the driveline to the outlet nozzle on your compressor.
2 Connect the other end of the driveline to the bottom of the nebuliser cup.
3 Remove the nebuliser chamber top from the cup and pour medication into the cup (max 10ml.)
4 Screw the top back onto the cup.
5 Connect either the face mask or mouthpiece to the nebuliser top.