Medivance ArcticSun 5000, Руководство по обслуживанию, Страница: 4 / 20

A S 5 0 0 0 S E R V I C E M A N U A L
2
• The Arctic Sun Temperature Management System is for use only with
ArcticGel Pads.
• Do not allow circulating water to contaminate the sterile field when
patient lines are disconnected.
• The rate of temperature change and potentially the final achievable
patient temperature are affected by many factors. Treatment
application, monitoring, and results are the responsibility of the
attending physician. If the patient does not reach target temperature
in a reasonable time or the patient is not able to be maintained at
the target temperature, an extended period of skin exposure to low
or high water temperatures may increase the risk for skin injury.
Ensure that pad sizing / coverage and custom parameter settings are
correct for the patient and treatment goals; environmental factors
such as excessively hot rooms, heat lamps, and heated nebulizers are
eliminated; water flow is greater than or equal to 2.3 liters per minute’
the primary patient temperature probe is properly located; and patient
shivering is controlled. Otherwise, consider increasing minimum water
temperature, modifying target temperature to an attainable setting, or
discontinuing treatment.
• The USB data port is to be used only with a stand-alone USB flash
drive. Do not connect to another mains-powered device during patient
treatment.
• Users should not use cleaning or decontamination methods different
from those recommended by the manufacturer without first checking
with the manufacturer that the proposed methods will not damage the
equipment. Do not use bleach (sodium hypochlorite) as it may damage
the system.
• Medivance will not be responsible for patient safety or equipment
performance if the procedures to operate, maintain, modify, or
service the Medivance Arctic Sun are other than those specified by
Medivance.
System Setup
Unpack
1) Unpack the Arctic Sun Control Module and accessories.
2) Allow the control module to remain upright for at least 2 hours prior
to completing the installation and setup procedure in order to allow
the chiller oil to settle. Damage to the chiller compressor may result
otherwise.
3) Connect the Fluid Delivery Line, Patient Temp 1 cable, Patient Temp 2
cable (optional) and Fill Tube to the back of the control module.
4) Plug the Power Cord into a hospital-grade wall outlet and power On.
The control module will automatically go through a brief self-test of the
independent safety alarms.
Fig. 1-1 Arctic Sun Model 5000 Control Module
Power Switch
Patient
Temp
Out
Fluid
Delivery
Line
Power Cord
Equipotential
Stud
Patient
Temp 1
Strain Relief
Patient
Temp 2
Patient
Temp Cable
Fill Tube
Parking
Fill Tube/Port
Drain Ports
Air Filter