Medisana 48614, Руководство пользователя, Страница: 24 / 42

7. Now move the thermometer smoothly over the patient’s eye-
brow from the forehead to the temple to measure the maximum
temperature. While the sensor scans this area, you will hear
slow beeps at first. As soon as the thermometer measures
higher temperatures, the beeps speed up. The sequence of
beeps then slows down to indicate that the maximum tempe-
rature has been recorded.
8. As soon as this happens, release the START button .
- If the reading is below the fever level, you will
hear a long beep and the backlight of the display
will be green.
- If the reading is at or above the fever level (37.8°C resp.
100°F), you will hear 10 short beeps, and the backlight of the
display will be red to indicate that the patient may have a fever.

9. When the °C symbol flashes again after 2 seconds,
the thermometer is ready for another reading.
3 Operation
GB
20
1. Move the selector switch to the bottom position to select
object temperature measurement mode .
2. Press the ON/OFF button . The LC display is activated.
The thermometer performs a self-test, where all the display
symbols are shown in succession.
3. Finally, the last registered reading is displayed along with the
M symbol (M = memory) for 2 seconds.
4. When you hear a short beep and the the symbol for the
measuring unit °C flashes, the thermometer is ready to take
the measurement.
5. To begin the measurement, point the sensor at the middle
of the object at a distance of no more than 5 cm. If it has water,
dust or dirt on it, remove this first so that the reading is as
accurate as possible.
6. Press the START button . The blue light switches on
and the temperature is measured. The measurement is
accompanied by a series of beeps.
7. Release the START button after a few seconds. A long
beep indicates the end of the measurement. Remove the
sensor from the measuring position. The display shows the
measured temperature.
3.4 Measuring the temperature of an object

 


 
