Medion F2 Revision 22, Руководство по эксплуатации

Страница: 50 / 70

28 of 48

Place the mobile rack onto a firm surface with the open side facing upwards. If
necessary, use a soft surface to minimise any knocks or collisions. The handle
must be facing in your direction.

Pull the hard drive decoupler out of the mobile rack.

The upper surface of the hard drive should be facing upwards
with the contacts located in the bottom right.
Now insert the hard drive at an angle into one side of the
mobile rack.
Ensure that both small hooks on the mobile rack slide into
the screw holes on the hard drive. Then carefully allow the
hard drive to slide completely into the mobile rack.

Press the hard drive decoupler back into the mobile rack.
Ensure that both metal pins slide into the screw holes on the
hard drive.

Carefully slide the mobile rack into the slot until it clicks into place.

Lock the mobile rack in place by pressing on the handle until it audibly clicks
into place. The hard drive will be recognised and can now be used.
9.2.3. Installing a 2.5” SSD drive in a 2.5”/3.5” mobile rack
When installing an SSD drive, follow the first four steps in the previous instructions
and then proceed as follows:

The upper surface of the hard drive should be facing upwards with the contacts
located in the bottom right.
Now insert the right side of the hard drive into the mobile rack.

Tightly hold the hard drive and the mobile rack, turn it over
and use four M3 x 4mm countersunk screws (not supplied)
to screw the hard drive in place using the corresponding
screw holes.
NOTICE!
The hard drive decoupler does not need to be replaced
because the hard drive has been sufficiently secured in
place by the screws.