Medion F2 Revision 22, Руководство по эксплуатации

Страница: 42 / 70

20 of 48
6. Starting up for the fi rst time
The operating system and all hardware drivers are pre-installed.
For some programs (e.g. telephone CDs or encyclopaedias), it may be necessary to
insert the relevant disc to call up the data stored on it. The software will prompt you
to do this if necessary.
Once you have made all of the connections and screwed on all of the required
connections, you can start up your PC:
6.1. Starting up your PC

Switching on the monitor.

Switch on the mains switch by moving it to the setting I . (Set this switch to 0 to
disconnect the power supply.)

Press the On/Off switch once to switch on your PC.
Your PC will now start and run through various steps.
PLEASE NOTE!
There should be no bootable disk in the optical drive
as this will prevent the operating system from being
loaded from the hard drive.
The operating system will be loaded from the hard disk drive. The loading process
takes a little longer during the initial setup. Once all the necessary data has been
entered, the operating system will be set up. The operating system is fully loaded
once the Windows® start-up screen appears.
PLEASE NOTE!
Data loss!
The initial installation may take a few minutes. Do not
disconnect the PC from the power supply during initial
installation and do not switch it off. This may adversely
affect the installation. Only switch off the PC when
installation has been successfully completed and the
start screen appears.

Follow the instructions on the screen. Step-by-step instructions will guide you
through the process to be followed.

The welcome procedure takes you through several screens and dialogues.

Choose your required language and then the country you require.