5
MOON BUGGY SET-UP
TO OPEN THE STROLLER
A
Lay the chassis down flat and release the frame lock
catch�
B
Adjust the handle to the user upright position by
simultaneously pressing the red buttons on the inside
of the handle� Grasp the handle and lift upwards
allowing the chassis to extend and click into position�
C
Check the stroller is ready for use by lifting the handle�
The stroller should not collapse�
TO INSTALL THE FRONT SWIVEL WHEEL
A
Remove the plastic protector (Where Fitted) from the front forks�
B
Push the front wheel axle fully into the wheel forks�
C
Place the securing washer on both sides, ensure the tabs in the washers are located
into the circular holes just above�
D
Tighten the front wheel axle by turning the quick release hub in a clockwise rotation
and fold lever to lock�
NOTE:
Pneumatic front and rear tyres can be inflated with pump (where supplied)
or a bicycle pump or at garage air pump and they have a maximum inflation
pressure of 2.4 bar (35 p.s.i).
TO INSTALL THE REAR WHEELS
A
Push each rear wheel into the chassis until
they lock into position�
B
Check the wheels are correctly fitted by
trying to pull them out�
NOTE:
The rear wheels can be removed
for more compact storage. Do this by
lifting the lock lever on the top of the rear
wheel housing, then pull the wheel out.
