5640.A
5
Operating Instructions
1.
Turn the unit on by pressing the power switch. The switch will illuminate when energized.
The controller will perform a self-test then will display the current temperature of the shelf
heater plates. The factory temperature setting is 104 degrees F. To change the temperature
setting, follow the instructions below.
2.
The controller will display 2 temperatures in its display. The top display number (in red) will
indicate the temperature of the top shelf heater plate. The bottom display number (in green)
will indicate the temperature of the bottom shelf heater plate. During the time that the
controller is directing the unit to warm a light will illuminate in the upper left corner of the
display.
3.
To change the temperature setting, follow the instructions below.
TO CHANGE THE SET POINT
PRESS THE INDEX KEY (LEFT MOST KEY) TO VIEW SET POINT ONE (SP1).
TOP SHELF.
PRESS THE INDEX KEY TWICE (LEFT MOST KEY) TO VIEW SET POINT TWO
(SP2). BOTTOM SHELF.
PRESS THE UP OR DOWN ARROW KEYS TO CHANGE THE SET POINT.
PRESS THE ENTER KEY (RIGHT MOST KEY) TO ACCEPT NEW SET POINT.
PRESS THE INDEX KEY.
3)
The shelves will operate independently from each other. When one shelf is not in use
decrease the set point for that shelf (below ambient temperature) to reduce operating cost.
4)
Reload the TEMP 2
after removing the bag.
NOTES:
The TEMP 2
may be left on continually without harm to the unit.
It is suggested that each
facility should contact the fluid manufacturer to obtain the manufacturer’s specifications
for time and temperature for the fluids being warmed.
The TEMP 2
is not intended for Blood or Blood Products.
In the event that fluid should spill inside the cabinet – unplug the unit to prevent an
electrical shock hazard and refer to step #4 of the Cleaning instructions.