EN
14
Instructions
1. Consult your family doctor before using this device.
2. Keep the device out of children’s reach.
3. Once the treatment is over, disconnect the device from the socket by unplugging
the adapter.
For the correct use and maintenance time of your new system for aerosol therapy, we
recommend reading the following indications carefully.
H
ow to use your M480 nebulizer for aerosol therapy
Make sure that the device and all the accessories are thoroughly clean, then proceed
consecutively with the following operations:
1. Position the device on a stable, bare flat surface (table without a tablecloth or other
covering) near a power point.
2. Open the device cover.
3. Remove the upper part as shown in Fig.1.
4.
Fill the tank with cold tap-water (distilled water or filtered water are not allowed,
using a small container as shown in Fig.2, to the level indicated inside the tank
(Fig.9): this water allows the conduction of ultrasound waves to the medicine and
is never nebulized.
5. Take a medicine cup with the medicine in it as shown in Fig.3.
6. Put the sealed ring on the machine around the mouth of the tank before placing
the medicine cup in.
7. Place the medicine cup with the medicine in its slot under the upper part of the
device (Fig.4), without spilling the drug from the medicine cup.
8. Place
the upper part onto the body of the device by carefully joining the two parts.
9.
Match the connector with the extension tube, then connect the free end of the
connector to the mask for nebulized drug emission (Fig.5), and apply the free
end of the extension tube to either of the two masks, the mouthpiece or the nasal
piece, according to the treatment required and to the mode of administration
selected.
10. Insert the current adapter into the socket on the back of the device.
11.
Warning! The air outlet is strictly prohibited from entering water. Please see Fig.8.
12.
Note the line for the water level in the water tank (see Fig.9); the water tank must
be used with tap-water, distilled water or filtered water are not permitted because
the sensor cannot work with them.
Now the device is ready for use.
