PERFORMER
Owner/User Manual MTS Performer rev. 01
Control Panel, Indicators & Connections.
Di OUT/MON
SELECT
Mic/Line Input:
Phantom Power.
On/Off, +48V to pins 2 and 3 of the XL connector
Peak LED.
Fires when signal envelope is within 6dB of clipping.
Signal Present LED. Fires when Signal envelope is within 30dB of Peak.
+48V Phantom LED Illuminated Blue = ON
Input Gain Control
For XLR connection, -60 -+4dBu
continuous gain range,
optimizes signal to noise ratio for 20dB of headroom throughout the
full gain range.
No pad? A 20 or 10dB pad will usually either give you
worse noise or less headroom, since 10 or 20dB is an arbitrary
number unlikely to ‘fit’ your actual gain needs.
Note: Using the Mic input XL is acceptable for Line input
use since its input range will accom4dBu nominal sources.
Line Input
Balanced line input, -40 to +44dBu input range on TRS
combo connector.
Note:
P
erformer input controls feature 41 position detents
allowing the user to note settings for future reference.
Hi-Z Input:
Signal Present/Peak.Function as per the Mic/Line Input.
Hi-Z Gain:
For 1/4” TRS connection, per Mic/Line Input, however
-42 - +4dBu gain range.
Network Return
Network Return(s) Signal Present, flashes when Signal is
present on the circuit.
For 1/4” TRS connection, per Mic/Line Input, however
-42 - +4dBu gain range.
Mon/Di-Out Sel.
Variable level control for ear buds, headphones etc.
Di-Out Select:
Routes selected input signal to phones
AND
Di-Out rear
XL connection.
Network Return:
Dante Networked audio return, single ch Balanced Line
or 2 ch “stereo”output.
User Selectable via PCB Jumper.
See block diagram. Factory default set to 2
channel/Stereo -2dBu output.
Page 15