PERFORMER
Owner/User Manual MTS Performer rev. 01
Network Return:
The Performer’s Network Return function, exactly as it implies, outputs two
return feeds
from
a Dante network. This useful feature can be configured in either
of two ways.
1. The default setting: A two channel (Stereo) Pair, i.e. Two discrete line level
channels routed back from the Dante network, converted to analog and available
at the front panel Network Return ¼” TRS ouput.
2. Alternatively a PCB jumper can be moved to configure the channel 1 Network
Return to single channel Balanced Line Out, +4dBu.
Note
: The Network Return ouput(s) are capable of directly driving most quality
wired headphones/ear buds to acceptable levels. However, there is no local
volume control on this output.
Re-configuration of the Network Return internal routing should only be
performed by qualified/authorized personnel. See warranty section.
Page 12
MONO BALANCED
Network Return
Output Selection
STEREO UNBAL.
CONTROL
PANEL
NETWORK
RETURN
OUTPUT
COMPONENT SIDE OF PCB
G7
22
50J
C115
L5
To change Network Return Output
from
default factory setting, 2 channel
unbalanced,
to
single channel balanced out, remove jumper from the left and
center pins, and re-position to the center and right pins, as shown below.
Note: Take care to identify on the outside of your Performer that it is
re-configured from the factory default setting to mono-balanced line out.
