Copyright Media Technologies 1999 - 2008
Page 3 of 19
1
QUICK START
Video inputs and control connectors are located at the front of the unit.
Video is output on the RCA/Phono connectors at the rear of the unit. The default input is Video
Channel-1 (C-Video-1), and Composite-video on all outputs.
IMPORTANT
Ensure the ‘Effect’ switch is set to zero on power-up unless you have installed a start sequence
mapped to the Effect switch.
The default magnification is set using the 'Split' switch. Split = 1 selects full frame video on each
monitor. Split = 2, selects 2x2, Split = 3 selects 3x3, Etc.
Connect your monitors according to the mapping shown on the processor rear panel.
Connect power, switch on the unit and your video source and monitors and you should see a high
quality magnified picture on the array of monitors.
The PC software needs to be installed to change the video input and output settings.
2
INSTALLING CONTROL SOFTWARE
Insert the Media Technologies software CD in the drive and the installer should automatically run.
If it does not run use Windows
TM
Explorer and double-click the file called ‘VideoWallControl.msi’
which will installs the software in a directory called ‘Videowall’ in the ‘Program Files’ directory.
It will also create a short cut on the desktop and a directory in ‘My Documents’ called ‘Videowall’.
This is the directory you should use for your video wall projects.
You can also install the software manually – see below.
Example Effects Sequences
A selection of sample effects sequences are provided on the CD.
Loop RS-232
(Slave processors)
Host RS-232
(Computer)
Select Effect
Video Input-1
Video Input-2
Video Outputs
at Rear
Earth Testing
Point
Default
Magnification
(Split)
