2
Set Up the Stand
Pillar (L1)
Center Pipe (1)
Center Pipe (2)
Pillar (R1)
1. Attach the Center Pipe (1) to the clamp on the Pillar (L1).
2. Attach the Center Pipe (2) to the clamp on the Pillar (L1).
3. Attach the Center Pipe (1) & (2) to the clamps on the Pillar (R1).
4. Attach the Side Arm (L1) to the clamp on the Pillar (L2).
5. Attach the Side Arm (L1) to the clamp on the Pillar (L1).
6. Attach the Side Arm (R) to the clamp on the Pillar (R2).
7. Attach the Side Arm
to the clamp on the Pillar (R1).
8. Attach the Side Arm (L2) to the clamp on the Pillar (L1).
Note:
Loosen or tighten the screws on the clamp with drum key as shown partial enlargement.
Adjust the height of the Side Arms with drum key as needed.
(R)
1
2
3
Side Arm (L1)
Pillar (L2)
Pillar (R2)
Side Arm (L2)
4
5
6
7
8
Wing Nut 1
Wing Nut 2
9. Attach the pad mounts to the mount holders on
the Center Pipe (1), Side Arm (L2), Side Arm
,
and firmly tighten the respective wing nuts 1.
Note:
Loosen or tighten the wing nuts on the mount
holder as shown partial enlargement.
Move the mount holders as needed, and firmly
tighten the respective wing nuts 2.
(R )
10. Insert the two cymbal holders into the holders on
the Pillars, attach the hi-hat holder to mount
holders on the Side Arm (L1), and firmly tighten
the respective wing nuts .
Note:
Loosen or tighten the wing nuts on the mount
holder as shown partial enlargement.
9
10
(R)
Side Arm
