R
L
R
L
INSTALLING A HARD DRIVE
b)
c)
d)
Make sure that the DC power cable is unplugged. Place the
rear panel screws as indicated in figure a. Lift the cover from the rear side and remove it. Plug the SATA
data and power cables into a compatible 2.5" HDD as shown in figure b. Turn the Hard Drive upside down
and carefully fit it into the Hard Drive bay.
Make sure the cables are not exposed or sticking out of the casing. Re fit the cover and tighten the
3 x rear screws.
Mede8er on a flat surface and unscrew the 3x
Place the heat conductive pad on the top side of the Hard Drive.
Two sizes are supplied so use the thicker one for 9mm hard drives and the thinner one for 13mm hard
drives.
e)
Unscrew the 3 securing screws. Hold the rear cover at its base as indicated by the blue arrows and twist outwards slightly
and then lift the cover up.
2.5" Hard Drive Bay
2.5" SATA Hard Drive
Page4
a)
Heat Conductive pad
