9
STORAGE
1) Switch off power from main and unplug, separate the pump from the mattress and place the mattress flat.
2) Fold the mattress in two from mattress foot to head.
3) Allow time for air to escape from mattress to reduce storage space.
4) Close the protective cap cover on the quick connector.
MAINTENANCE
In case of repair, use only original spare parts and accessories.
CLEANING AND DISINFECTION
WARNING!
Unplug the pump before starting the cleaning procedure.
1. Clean the mattress with mild soap.
2. Do not immerse or soak pump unit.
3. After cleaning, dry the mattress without direct sunlight exposure.
4. Check that the connection tubes are not obstructed by dust or other object. Use a soft swab to clean the tubes if necessary.
NOTE
Never use acids, alkalis or solvents such as acetone to clean the mattress.
CONDITIONS OF DISPOSAL
General conditions of disposal
Dispose the device in the appropriate disposal areas for recycling.
At the end of its life, the products must not be disposed of along with other domestic waste.
Dispose this equipment by bringing it to a specific recycling point for electric and electronic equipment or
others that provide this service.
SPARE PARTS/ACCESSORIES
For spare parts and accessories please contact MedaCure or authorized dealer.
TROUBLESHOOTING
If your questions can’t be answered with below information, please contact your local agent directly. They might require a
technician to take care of the problem.
No lights on unit
Check control unit is connect to the mains power supply and
t
hat the unit is switched on.
Check quick blow fuse on the control unit or mains plug fuse.
Low pressure alert
Check main power to the control unit and that the plug is switched.
Check mattress air supply connector is connected to the pump unit
correctly.
Check CPR connector is connected properly.
Under the mattress cover check all “T”&”L”connectors are
connected to the air tubes.
Check the connector tubes for kinks, crimps or damage.
Patient’s body is sagging in
the middle/bottoming out
Increase the
comfort
level
setting. Wait a couple of
minutes so pressure can stabilize before making another change.
Control lock up or “freeze”
Turn the control unit off and unplug the pump.
Wait a few minutes and plug the control unit back
o
n. Turn on
the control unit.
