P/N 03.1543.07
REV. 10/06
4
FIG. 2A
FOR 9000 SERIES
ELECTRIC GRILLS
FIG. 2C
FIG. 2D
8
ASSEMBLY:
1. Remove COOKING GRIDand store away. Rotate ELE-
MENT (1) to the ROTISSERIE position with the Control Knob
(2)
(FIG. 2A)
.
2. Place the wide bottom end of the MOTOR BRACKET (3)
into slot between left grill handle and bowl. Push Bracket
down to snap in place. Hang the MOTOR (4) in the keyhole
slot in the MOTOR BRACKET(3).
3. Slide a SPIT FORK (5) with Thumbscrew toward Handle
onto the SPIT SHAFT (6)
(See also Fig. 2B)
. Tighten thumb
screw. Slide the other SPIT FORK (5) opposite the first SPIT
FORK onto the SPIT SHAFT.
Insert the pointed end of the SPIT SHAFT (6) through the
MOTOR BRACKET (4) and into the square hole in the
MOTOR (4). Place the groove nearest the handle into the
NOTCH (7) in the bowl.
ROTISSERIE COOKING:
1. Remove the first SPIT FORK. Insert pointed end of Spit
Shaft through the center of piece of meat, or through body
cavity of a fowl
(FIG. 2C)
.
FIG. 2B
Make sure prongs of spit fork are securely engaged in meat.
Slide the spit fork back onto spit shaft and into meat, and
tighten thumb screw.
2. Check for balance by turning shaft in your hand. Adjust and
tighten thumb screws with pliers or wrench if needed. You
may have to tie loose sections of meat, such as wings and
legs of a fowl, with string to keep them off element.
Rotate Element to ROTISSERIE position and place a shallow
drip pan in bottom of bowl. If you do not have a drip pan of
suitable size, make one out of aluminum foil. Make it so it is
about 1-inch larger than piece of meat you are cooking. Use
a double layer of aluminum foil and pinch corners of foil so it
will hold drippings. Pinch corners of foil so it will hold
drippings.
3. Adjust Temperature Control (8) of electric grill to #2 Medium
position
(FIG. 2D)
. Leave hood open for slowest possible
cooking, or shut hood for fastest cooking.
4. To start the HEAVY DUTY ELECTRIC motor, plug the cord
into any properly grounded 110-120 volt AC outlet and turn
Motor swittch ON. To stop, turn the Motor switch OFF and
unplug the cord. To start PORTABLE BATTERY POWERED
MOTOR, insert a D-Cell battery into housing and turn switch
to on. To stop, turn switch off.