16 – RULES FOR A GOOD WORK
The engine should be put through a ‘running in’ period ( for at least 10 hours do not use more of the 70%
of the available power of the engine)
- always use the clutch before operating any levers or rods
- do not over use the clutch disengagement.
- never press the guide pulley levers, wheel disengagement or the PTO rod. If they will not engage move
the machine with engaged wheels or with the guide pulley levers lowered by using a little pressure on the
lever or rod that is hard to engage.
- keep the handlebar joint cleaned and oiled
- never over work the engine; if smoke appears from the exhaust pipe, this means that the engine is being
put under stress
- never work for long periods at maximum power, especially in hot periods
- periodically check the pressure of the tyres (1.3 Bar)
- when mounting the cutter bar, pay particular attention not to damage the centring and the grooves of the
shafts, check the screws and the blocking pins are well tightened especially the screws that fix the cutter bar
- never leave the machine out in the rain.
17 – DECLARATION OF CONFORMITY
- GB - CE – DECLARATION OF CONFORMITY
In compliance with CEE 89/392 regulations and subsequent changes
0000000001
From series-no.:
F 213
Model:
MECCANICA BENASSI S.p.A ,
I-44040 DOSSO (FE) via Statale, 325
DECLARES, under is own responsibility, that the item called
MOTORMOWER
* The number is printed on the machine’s gearbox .
is manufactured by the above company in compliance with basic safety and health
safeguard requirements specified in the regulation CEE 89/392 and subsequent changes.
For checking the conformity with the above regulations, have been examined the following
CEN rules: CEN UNI EN 709:98/A1 :2000.
Dosso, (Italy) , the 13th July, 2005
MECCANICA BENASSI SPA
L’Amministratore Unico
- 10-