PCI-QUAD04 User's Guide
Installing the PCI-QUAD04
Termination resistors
Although termination resistors typically are not required, SMT pads on the PCI-QUAD04 are open and labeled
to allow you to install terminating resistors from the various inputs to ground.
Table 2-2. Termination resistor settings
Channel
Input
1 2 3 4
Phase A+
R9
R22
R38
R30
Phase
A-
R10 R23 R39 R31
Phase
B+
R11 R20 R36 R28
Phase
B-
R12 R21 R37 R29
Index+
R14 R19 R35 R27
Index-
R13 R18 R34 R26
Installing the PCI-QUAD04
After configuring the PCI-QUAD04, install the board in your computer. Follow the steps below.
Install the MCC DAQ software before you install your board
The driver needed to run your board is installed with the MCC DAQ software. Therefore, you need to install the
MCC DAQ software before you install your board. Refer to the
Quick Start Guide
for instructions on installing
the software.
1.
2.
3.
Turn your computer off and open it up.
Close your computer and turn it on.
If you are using an operating system with support for plug-and-play (such as Windows 2000 or
Windows XP), a dialog box opens as the system loads, indicating that new hardware has been detected. If
the information file for this board is not already loaded onto your PC, you are prompted for the disk
containing this file. The
Measurement Computing Data Acquisition Software
CD supplied with your board
contains this file. If required, insert the disk or CD and click
OK
.
To test your installation and configure your board, run the
Insta
Cal utility installed in the previous section.
Refer to the
Quick Start Guide
that came with your board for information on how to initially set up and
load
Insta
Cal.
Connecting the board for I/O operations
Connectors, cables – main I/O connector
Table 2-3
Table 2-3. Board connectors, cables, and accessory equipment
lists the board connectors, compatible cable, and compatible accessory products for the PCI-
QUAD04.
I/O connector type
37-pin connector
Compatible cable
C37F-4X9F-1M
2-3
Содержание PCI-QUAD04
Страница 1: ...i HM PCI QUAD04 doc ...
