Measurement Computing PCI-QUAD04, Руководство пользователя

Страница: 10 / 18

PCI-QUAD04 User's Guide Installing the PCI-QUAD04
Unpacking the PCI-QUAD04
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the PCI-QUAD04 from its packaging, ground yourself using a wrist strap or by
simply touching the computer chassis or other grounded object to eliminate any stored static charge.
If any components are missing or damaged, notify Measurement Computing Corporation immediately by
phone, fax, or e-mail:
! Phone: 508-946-5100 and follow the instructions for reaching Tech Support.
! Fax: 508-946-9500 to the attention of Tech Support
! Email: techsupport@mccdaq.com
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data
Acquisition Software CD . This booklet is available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-
Quick-Start.pdf .
Configuring the PCI-QUAD04
Before installing the board, configure the channel input mode for either single-ended or differential. You set the
channel configuration with a set of jumper blocks on the board. Each jumper is labeled for its functionality. By
default, the board is shipped with the channels configured for single-ended operation, with no termination
resistors installed.
Channel input mode
To configure for single-ended operation, place a jumper between pin 2 and pin 3 (labeled
SE
). To configure for
differential operation, place a jumper between pin 1 (labeled
DIFF
) and pin 2. A single-ended configuration is
shown in . Figure 2-1
Figure 2-1. Channel input mode configured for SE operation
Input mode jumper settings are listed in . Table 2-1
Table 2-1. Channel input mode jumper settings
Input channel
Input 1 2 3 4
Phase A P3 P8 P14 P11
Phase B P4 P7 P13 P10
Index P5 P6 P12 P9
2-2