6
introduction
How to connect this product
• Configuration via a wired LAn (recommended)
The WTS is connected to your network using a standard
network cable and configured from the PC.
• Configuration via a wireless LAn
The network settings are configured on the WTS by
establishing a wireless connection between a PC and the
WTS in AdHoc mode. To communicate with this product
in AdHoc mode, the wireless setting on the PC must be the
same as the WTS.
• Configuration via Windows “Connect now“
This product supports “Windows Connect Now“, which is
one of the functions installed in Windows XP SP2.
Windows Connect Now enables connection of the WTS to a
wireless LAN by utilizing a wireless PC (Windows XP SP2)
a USB memory ‘Flash Drive‘.
This Setup Guide describes how to configure this product
using a wired Ethernet cable connection, which corresponds
to “Configuration via a wired LAN“.
• Cable connection example 1
• Cable connection example 2
This product can be configured in three ways, as listed below:
network
cable
Ethernet Hub
Meade Wireless
Telescope Server
Meade Wireless
Telescope Server
Access point
network cable
