Mea SMAC 40D-15HP, Руководство владельца/оператора

Страница: 16 / 34

Document No 7201-D0001-13 12
INSTALLATION - continued
2.2 Setup and run the system at 120 PSI. This can be done by installing a ball valve on the air
outlet pipe and adjusting the opening of the valve so that the compressor is running continuously at 120
PSI.
2.3 Record the engine, compressor, and current ambient temperature for future reference.
2.4 Run the system at full load for at least one hour or until the temperatures stabilizes.
Temperature stabilizing means there is no rise in temperature for 15 minutes when the compressor is
running at the rated load.
2.5 Record the engine and compressor temperatures every 10 minutes.
2.6 If the system over-heats, the ventilation is not sufficient, review the installation, make changes
as needed, and repeat the test.
3 Engine Exhaust consideration when installing Diesel Engine Driven Compressor Unit
In cases that the exhaust system needs to be ducted away from the engine assembly, the following are
a minimum that should be considered
▪
The exhaust pipe needs to be adequate for the engine.
▪
There needs to be a flexible joint at the point where the extension is connected to the exhaust
system of the Diesel Engine Driven Compressor Unit.
▪
Ensure the exhaust pipe has suitable clearance and does not meet anything.
▪
Ensure that if the exhaust system has a method to prevent water from entering the exhaust
system.
▪
Ensure exhaust from the diesel engine is routed in a way to prevent recirculation back into the
unit.
4. Securing the Diesel Engine Driven Compressor Unit to the body of the vehicle.
It is important to consider maintenance needs, (daily needs), service requirements, electrical
connections, air connections, location of control panel before the SMAC is secured to the body of the
vehicle.
▪
Locate a suitable mounting position for SMAC. Place the unit and check for clearances to any
other objects.
▪
There are four weld nuts located at the four corners of the bottom formed plate which can be
used as mounting bolt locations. Holes can also be drilled through the bottom of the formed
plate if alternate locations are required.
▪
Drill four holes in mounting surface and secure the SMAC to the truck. Use a minimum of 4
–
M12 bolts.