Technical Manual Temperature Controller
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49
-2263-4588
• [email protected] • www.mdt.de
30
At the read in of a new absolute comfort setpoint, the controller becomes a new basis comfort
setpoint. The new basic comfort setpoint causes also an adaption of the indirect setpoints at the
other operating modes. Through this function it is for example possible to read the actual room
temperature as new basic comfort setpoint i
. The setti gs a setpoi t offset , a setpoi t
offset alid fo a d Reset setpoi t offset afte ha ge of ode a e ot alid at this a ia t of
setpoint offset, because the controller becomes a complete new setpoint. Specifying a new value is
poss
i le alli g the o je t “etpoi t o fo t .
The second opportunity of the manual setpoint offset is the movement of the setpoint depending to
the u e t adjusted setpoi t. Fo this a ia t of setpoi t offset, the o je t a ual setpoi t alue
offset i
s used. Sending a positive Kelvin value at this object causes an increment of the current
setpoint. Sending a negative Kelvin value at this object causes a decrement of the current setpoint.
The setti g a setpoi t offset i di ates the a i al possi le
setpoint movement. If the controller
is for example set to a basic comfort setpoint of 3K, the setpoint can only be moved manual in the
limits of 18°C and 24°C.
The manual setpoint value offset is also possible via a 1 Bit object. In this case, normal 1 Bit
o
a ds a e se t to the Bit o je t „Ma ual setpoi t alue offset . B
sending a 1 , the setpoint
will be increased by the adjusted step range, sending a 0 decreases the setpoint by the adjusted step
range.
The setti g a setpoi t offset alid fo d
efines the scope of the setpoint offset. You can choose
whether the setpoint offset is only valid for the comfort mode or also for the night and standby
mode. The operating mode frost/ heat protection is always independent of the setpoint offset.
The setti
g „Reset setpoi t afte ha ge of ode i di ates hethe a setpoi t offset shall e
maintained after a change of mode or not. If this parameter is deactivated, the device will switch to
the adjusted setpoint for the chosen operating mode after every change of mode.
The o
u i atio o je t A tual setpoi t is fo the ue of the u e t setpoi t at the a tual
adjusted operating mode.
The following chart shows the relevant communication objects:
Number
Name
Length
Usage
6
Setpoint comfort
2 Byte
Parameterization of a new absolute comfort
setpoint
7
Manual setpoint value offset
2 Byte
Movement of the setpoint depending to the
current adjusted basic comfort setpoint
24
Actual setpoint
2 Byte
Readout of the actual adjusted setpoint
27
Setpoint offset
1 Bit
Movement of the setpoint by the adjusted step
range
Table 25: Communication objects setpoint offset
