T
ROUBLE SHOOTING THE SYSTEM
We have put together this trouble-shooting guide if you experience problems after
installing the amplifier. Please keep in mind that the majority of problems incurred are
caused by improper installation and not the equipment itself. In addition, there are many
components in the system that could cause various signal problems such as inducted
electrical noise and engine noise.
Before you can properly address the problem, you must first find the component that is
causing the problem. This will take patience and a process of elimination.
LOOK FOR....
SOLUTION
No Output
Blown fuse
Replace
Bad RCA Cable(s)
Replace
+12V at power terminal
Check connection
+12V at remote terminal
Check connection
Grounding point clean and tight
Check for ground w/meter
Head Unit's fader not in center position
Set to center position
Low Output
Check level adjustments
Re-adjust
Bad RCA cable(s)
Replace
Improper level matching
Re-adjust
Engine Noise
Grounding points are clean and tight
Check for ground w/meter
Ground all components at same point
Ground at same point
Try different grounding point
Change for better ground
Bad RCA cable(s)
Replace
Use High Quality shielded RCA cables
Rejects inducted noise
Low Vehicle charging system and/or battery
Fix and/or replace
Protection L.E.D. Illuminated
Speaker short
Check speakers connection
for short circuit
Speaker grounding out
Make sure speaker wires
do not touch chassis ground
Impedance too low
Check speaker impedance
(Min 2 ohm )
Overheating
Check mounting location
for Adequate air Circulation
Speaker impedance too low
12
