10
MDS 4710/9710 I/O Guide
MDS 05-3305A01, Rev. B
with the use of the
DATAKEY
command.
Additional connections may be required for some installations.
Refer to the complete list of pin functions provided in Table 4 on
page 14.
4. Measure and install the primary power for the radio. The red wire on
the power cable is the positive lead; the black is negative.
NOTE:
Use the radio in negative ground systems only.
5. Set the radio configuration. The transceiver is designed for quick
installation with a minimum of software configuration required in
most cases. The selections that must be made for new installations
are:
• Transmit frequency
• Receive frequency
The operating frequencies are not set at the factory unless they were
specified at the time of order. Determine the transmit and receive
frequencies to be used, and follow the steps below to program them.
6. Connect a hand-held terminal (HHT) to the
DIAG.
connector. When
the HHT beeps, press
to receive the ready “>” prompt.
a. Set the operating frequencies using the
TX xxx.xxxx
(transmit) and
RX xxx.xxxx
(receive) commands.
Press
after each command. After programming, the HHT
reads
PROGRAMMED OK
to indicate successful entry.
ENTER
ENTER
