MDS entraNET 2400, Инструкция по установке и эксплуатации

Страница: 200 / 208

192 MDS entraNET System Guide MDS 05-4055A01, Rev. C
DCE—Data Communications Equipment. In data communications ter-
minology, this is the “modem” side of a computer-to-modem connec-
tion. The transceiver
COM1
and
COM2
ports are set as DCE.
Decibel (dB)—A measure of the ratio between two signal levels. Fre-
quently used to express the gain (or loss) of a system.
DES—Data Encryption Standard. More information on DES is avail-
able at www.itl.nist.gov/fipspubs/fip46-2.htm.
DHCP—Dynamic Host Configuration Protocol. An Internet standard
that allows a client (that is, any computer or network device) to obtain
an IP address from a server on the network. This allows network admin-
istrators to avoid the tedious process of manually configuring and man-
aging IP addresses for a large number of users and devices.
When a network device powers on, if it is configured to use DHCP, it
contacts a DHCP server on the network and requests an IP address. The
DHCP server provides an address from a pool of addresses allocated by
the network administrator. The network device may use this address on
a “time lease” basis, or indefinitely, depending on the policy set by the
network administrator.
DNP3—Distributed Network Protocol 3. DNP3 is an industry-standard
protocol that was initially created for communication between electrical
substation devices. Today, this non-proprietary protocol is being widely
adopted for a variety of other applications. Although DNP3 is typically
employed in a client-server environment, this serial protocol is one of
only a few that allow peer-to-peer communication between devices
without the need for a host computer. It does this in the same way that
IP supports peer-to-peer communication in an Ethernet environment.
Encapsulation—Process by which a complete data packet, such as
MODBUS frame or any other polled asynchronous protocol frame, is
placed in the data portion of another protocol frame (for example, IP) to
be transported over a network.
Typically this action is done at the receiving end, before being sent as
an IP packet to a network. A similar reversed process is applied at the
other end of the network extracting the data from the IP envelope, result-
ing in the original packet in the original protocol.
Endpoint—Ethernet or IP data equipment connected to the ports of the
transceiver.
Fade Margin—The greatest tolerable reduction in average received
signal strength anticipated under most conditions. Provides an allow-
ance for reduced signal strength due to multipath, slight antenna move-
ment or changing atmospheric losses. A fade margin of 15 to 20 dB is
usually sufficient in most systems.