MDS 4710B, Инструкция по установке и эксплуатации

Страница: 28 / 56

20 MDS 4710B/9710B I/O Guide MDS 05-3316A01, Rev. E
MODEM [NONE, BELL,
4800B, 9600B] Details
page 26
Set or display the modem type used in the radio.
None indicates an analog input.
OWM [XXX...] Details
page 27
Set or display the owner’s message.
OWN [XXX...] Details
page 27
Set or display the owner’s name.
PTT [0–255] Details page
27
Set or display the Push-to-Talk delay in
milliseconds.
PWR [20–37] Details
page 27
Set or display the transmit power setting.
RSSI Details page 28 Display the Received Signal Strength Indication.
RTU [ON/OFF/0-80]
Details page 28
Re-enables or disables the radio’s internal RTU
simulator and sets the RTU address.
RX [xxx.xxxxx] Details
page 28
Set or display receiver frequency.
RXLEVEL [–20...+3]
Details page 28
Set or display the analog audio receive level in
dBm.
SCD [0-255] Details page
29
Set or display the Soft-carrier Dekey delay in
milliseconds.
SER Details page 29 Display the radio serial number.
SHOW [DC, PORT, PWR]
Details page 29
Display the DC voltages, diagnostics port, and
transmit power level
SREV Details page 29 Display the Software Revision Level
STAT Details page 29 Display radio status and alarms
STE Details page 30 Display whether the Squelch-Tail Eliminator is ON
or OFF.
SWC [ON, OFF] Details
page 30
Set or display the master station carrier mode.
TEMP Details page 30 Display the internal temperature of the radio in
degrees C.
TOT [1-255 ON/OFF]
Details page 31
Set or display the Time-out Timer delay in
seconds.
TX [xxx.xxxxx] Details
page 31
Set or display the transmit frequency.
TXLEVEL [–20...+3,
AUTO] Details page 31
Set or display the analog audio transmit level in
dBm.
Table 8. Operating parameter commands(Continued)
Command name Function