MDS 05-3316A01, Rev. E
MDS 4710B/9710B I/O Guide
13
3. If not done earlier, refine the antenna heading of the station to maxi-
mize the received signal strength (RSSI) from the master station.
Use the
RSSI
command from an HHT connected to the radio’s
DIAG-
NOSTICS
connector.—See TRANSCEIVER PROGRAMMING on
page 15. This can also be done with a DC voltmeter as described in
3.3 RSSI Chart
3.2 Reading LED Status Indicators
Table 6 describes the function of each status LED.
Invisible place holder
Figure 8. LED Status Indicators
Invisible place holder
PWR
DCD
TXD
RXD
Table 6. LED status indicators
LED Name
Description
PWR
• Continuous—Power is applied to the radio, no faults detected.
• Rapid flash (five times-per-second)—Fault indication. Refer to
Checking for Alarms—STAT command on page 32
• Moderate flash (one time-per-second)—Internal firmware error.
Refer to Upgrading the Radio’s Software on page 37
• Off—No power is applied to the radio or the radio is in Sleep mode.
Refer to Using the Radio’s Sleep Mode on page 7
DCD
• Flashing—Indicates the radio is receiving valid data frames.
• Continuous—Radio is receiving a data signal from a continuously
keyed radio.
TXD
An RS-232 mark signal is being received at the DATA INTERFACE.
RXD
An RS-232 mark signal is being sent out from the DATA INTERFACE.
Содержание 4710B
Страница 1: ...Installation and Operation Guide MDS 05 3316A01 REV E SEPTEMBER 2000 Data Transceiver MDS 4710B 9710B...
Страница 8: ...vi MDS 4710B 9710B I O Guide MDS 05 3316A01 Rev E...
Страница 48: ...40 MDS 4710B 9710B I O Guide MDS 05 3316A01 Rev E...
Страница 54: ...I 6 MDS 4710B 9710B I O Guide MDS 05 3316A01 Rev E...
