M D C R O M A N I , I N C .
P a g e
|
2
7 2 4 - 4 6 3 - 6 1 0 1 ● C l i p p e r V a c . c o m ● i n f o @ c l i p p e r v a c . c o m
Step 9
Make sure that you have a hold of the motor from the bottom. Using you
finger pop up the rubber boot and the motor will fall through the motor ring.
Step 10
Pull the motor down and out to remove.
Step 11
Insert the new motor up through the motor ring.
Note:
For Tote® models you must insert the motor without the filter connected.
Step 12
Use a book, block, box, etc., to hold the motor high enough so you can fold
down the rubber boot.
Step 13
Using your fingers gently folds the rubber boot over the motor ring.
Step 14
Reinstall the Motor Clamp. Make sure the cardboard is inserted between the
rubber boot and the clamp. It is very important that this step is correct. The
cardboard is to insure that the clamp does not split the rubber boot.
Step 15
Using your 5/16 ratchet, tighten the motor clamp. Be Careful not to over
tighten.
Step 16
Locate the white wire with the blue wire end. Gently plug-in the wire
Step 17
Locate the black wire with the brass wire end. Gently plug-in the wire
Step 18
Using your wire strippers, strip the ground wire still connected to your unit.
Step 19
Twist together the ground wire from your unit with the new motor ground
wire. Insert twisted wires into the yellow wire cap. Turn wire cap until snug.
Wire cap correctly connected.
Step 20
Tuck all loose wires into the foam to make sure they do not get into the
motor.
Step 21
Make sure to plug in your unit and test run the motor before replacing the lid.
Step 22
Gently replace foam to its original position.
Note:
If your unit is a Tote®, Model 1® or Model 1A® you do not need to reseal the
lid. Please skip steps 23, 24 and 26.
