MD mXion HDD, Руководство пользователя

Страница: 23 / 30

23
HDD
CV-Table
CV Description S L/S Range Note
7 Software version – – read only (10 = 1.1)
7
(1)
Decoder reset functions
6 ranges available
11
16
33
66
77
88 basic settings (CV 1,11-13,17-19,29-119)
programming lock (CV 15/16)
function- & Switch outputs (CV 120-139)
servo and turntable address (CV170-190)
array & steps (CV 191
– 268)
direct addresses (CV 275 – 418)
8 Manufacturer ID 160 – read only
7+8 Register programming mode
Reg8 = CV-Address
Reg7 = CV-Value
CV 7/8 don’t changes his real va lue
CV 8 write first with cv-number, then CV 7
write with value or read
(e.g.: CV 49 should have 3)
➔
CV 8 = 49, CV 7 = 3 writing
15 Programming lock (key) 195 LS 0 – 255 to lock only change this value
16 Programming lock (lock) 195 LS 0 – 255 changes in CV 16 will change CV 15
48 Switch address calculation 0 S 0/1 0 = Switch address like norm
1 = Switch address like Roco, Fleischmann
49
(2)
MD configuration 0 S bitwise programming
Bit Value OFF (Value 0) ON
0 1 A3 normal function A3 flashes while turning
1 2 A4/A5 normal function A4/A5 light signal
2 4 Stepper normal Stepper invers
3 8 Stepper single normal Stepper single invers
4 16 Stepper 180° normal Stepper 180° invers
5 32 Stepper drive direction normal Stepper drive direction invers
6 64 Stepper not hold endposition Stepper hold endposition
7 128 Light signal switch Light signal fading
96 Working mode 0 W 0/1 0 = DCC, 1 = MM (automatic syste)
107 Segment/Stage-Mode 0 W 0/1 0 = normal turntable (round), 1 =
Segment/Stage (stops at end)
112 Turntable mode 0 S 0 – 5 0 = Self build/extern turntable
1 = Heyn 720/830 mm
2 = Heyn 600/670 mm
3 = Heyn 500/600 mm
4 = Heyn 380/450 mm
5 = Heyn 210/300 mm
113 Calibration
(will done after 1. start)
0 S 0/1 0 = not calibrated
1 = calibrated