MCZ FORMA WOOD 75 DX-SX, Инструкция по использованию и установке

Страница: 17 / 30

FORMA WOOD CLOSED FIREPLACE Chapter 4
USE AND MAINTENANCE MANUAL
page
17
Installation and assembly Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
Remove the closed fireplace from the pallet as follows:
 Remove plate A by unscrewing the two screws
 Remove the two screws from bracket B
Insert the feet or wheels (supplied), by raising them and inclining them
slightly to allow you to extract them. You will then be able to remove
the 4 locking “ B ” brackets.
Pay particular attention to the door and its glazing to protect them from
mechanical knocks which would compromise their proper working
order.
In all cases, appliances must be handled with care. If possible, unwrap
the closed fireplace near the chosen place of installation.
The materials making up the packaging are neither toxic nor harmful
and, as such, require no special disposal measures.
Storage, disposal and any recycling is the responsibility of the end user,
in compliance with the applicable laws in force.
4.2.
OPERATING MODE SELECTION
IMPORTANT!
Decide which system to use before installing the
appliance.
The FORMA system is able to distribute hot air via NATURAL
CONVECTION (COMFORT AIR NV) or FORCED CONVECTION
(COMFORT AIR FV) using a forced ventilation kit.
4.2.1.
Natural convection (COMFORT AIR NV)
In natural ventilation air enters the bottom of the closed fireplace
naturally.
4.2.2.
Forced convection (COMFORT AIR FV)
If you adopt this system purchase the Comfort Basic Air Kit or optional
Comfort Air Slim kit and follow the instructions provided with each kit.
4.3.
COUNTERWEIGHT UNLOCKING
The closed fireplace is supplied with the sliding counterweights locked
to prevent dangerous knocks during transport and positioning that may
damage the parts involved in the sliding action, the door and the glass-
ceramic.
To unlock the counterweight and then the door, remove the screws as
shown in figure 1 from both sides of the closed fireplace in
correspondence with the arrow stickers positioned on both sides.
Figure 1 – Counterweight locking screws