5
1-WARNINGS AND WARRANTY CONDITIONS
Technical Dept. - All rights reserved - Reproduction prohibited
INFORMATION:
Please contact the retailer or qualified personnel authorised by the company to resolve a problem.
•
You must only use the fuel specified by the manufacturer.
•
When the product is switched on for the first time it is normal for it to emit smoke due to the paint heating for the first time.
Therefore make sure the room in which it is installed is well ventilated.
•
Check and clean the smoke outlet pipes regularly (chimney fitting).
•
The product is not a cooking appliance.
•
Always keep the cover of the fuel hopper closed.
•
Store this installation guide with care as it must accompany the product for the duration of its useful life. If the product is sold or
transferred to another user, ensure the manual is also handed over.
INTENDED USE
The product only works with wood pellets and must be installed indoors.
PRODUCT PERFORMANCE CHECKS.
All our products undergo ITT tests carried out by a notified laboratory (system 3) and in accordance with (EU) regulation number 305/2011
“Construction products”, according to standard EN 14785:2006 (pellets) and “Machinery Directive” EN 303-5 (boilers).
In the case of tests for any market surveillance or inspections by third parties, please consider the following warnings:
•
to reach the declared performance levels, the product must perform an operating cycle of at least 15/20 hours beforehand.
•
use the average draught of the combustion smoke specified in the “technical product features” table.
•
the type of pellets used must comply with current EN ISO 17225-2 regulations.
•
the amount of fuel may vary according to the length and calorific value of the fuel. This may require some adjustments to stay in line
with the hourly consumption specified in the “technical product features” table. A1 pellets ensure an overall calorific value within
tight margins compared to the test pellets used. However, size considerably influences performance, so on average it must not be
less than 24 mm long and with a 6mm diameter.
•
in the case of a wood-burning product, check the correct residual moisture content of the fuel, which must not be less than 12% or
more than 20%. As the moisture increases, different combustion air settings are required. The settings are to be carried out via the
combustion air register, thereby modifying the mixture between primary and secondary air.
•
it is necessary to check the operation of devices that can affect performance (for example air fans or electrical safety devices) in case
of damage due to handling.
•
maximum performance can be achieved at the maximum flame and ventilation power.
•
strictly comply with the withdrawal points specified in regulations both in terms of emissions and temperature.
WARRANTY CONDITIONS
The company guarantees the product,
with the exception of elements subject to normal wear
(listed on the following page), for a
period of
2 (two) years
from the date of purchase attested by:
•
a document to serve as proof of purchase (invoice and/or receipt) that shows the name of the vendor and the date on which the
purchase was made;
•
forwarding of the completed warranty certificate within 8 days of purchase;
Furthermore, in order for the guarantee to be valid, the device must be installed and calibrated by qualified personnel, and where
necessary, the user must be issued with a declaration of conformity and correct functioning of the product.
We recommend testing the product before completion with the relative finishes (cladding, painting of walls, etc.).
Installations that do not meet the current standards, improper use and lack of maintenance as expected by the manufacturer, void the
product warranty.
The warranty is valid on the condition that the instructions and warnings contained in the user and maintenance manual are observed,
and therefore the product is used correctly.
