McQuay MicroTech MAG, Установка и обслуживание данных

Страница: 13 / 41

IM620-1 13
PC Specification
A direct connected computer can be used for monitoring MAG Panel and unit operation. The PC must
be an IBM or 100% true compatible. Table 7 shows the preferred and minimum PC specifications.
Network Master Panel
The MicroTech Network Master Panel (NMP) allows the MAG Panel(s) and associated units to be
incorporated into a building-wide network with other MicroTech unit and auxiliary controllers. In
conjunction with a PC and Monitor software, it gives the building operator the capability to perform
advanced equipment monitoring from a central or remote location.
For further information, contact your McQuay sales representative.
Open Protocol
MicroTech Open Protocol™ provides an interface between the MAG Panel and the building
automation system of one of many participating manufacturers. With Open Protocol, the building
automation system can do the following:
•
Monitor most controller setpoints, parameters, and alarms
In an Open Protocol application that includes one MAG Panel, the MicroTech Open Protocol Master
(OPM) Panel is not required because the MAG can connect directly to the BAS interface. If two or
more MAG Panels are included, the MicroTech Open Protocol Master (OPM) Panel is required. For
further information, contact your McQuay sales representative.
Table 7. PC Specification
Preferred Configuration Minimum Configuration
486DX processor, 66MHz or better 386SX processor, 16 MHz
8 MB of RAM or better 4 MB of RAM
120 MB hard disk drive or better 60 MB hard disk drive
3½” floppy disk drive 3½” floppy disk drive
Serial port (9 pin male; Com1 or Com2) Serial port (9 or 25 pin male; Com1 or Com2)
Parallel port –
Internal time clock, battery backed Internal time clock, battery backed
Super VGA graphics capability VGA graphics capability
Super VGA monitor VGA monitor
Printer –
Bus mouse or trackball Serial mouse or trackball*
101 enhanced keyboard 101 enhanced keyboard
9600 bps modem, compatible with the AT command set
(optional) 1200 bps modem, compatible with the AT command set
(optional)
MS-DOS® 6.2 or higher MS-DOS® 5.0
Microsoft® Windows™ 3.1 or higher Microsoft® Windows™ 3.1
MicroTech® Monitor™ for Windows software MicroTech® Monitor™ for Windows software
* If a serial pointing device is used, there must be another serial port (Com1 or Com2) available for connecting the PC to the
MicroTech controller.