www.mcohome.com User Manual
2
Wiring
(standard strip length: 6-8mm)
MH-S411, MH-S411H
MH-S412
Operation
INCLUDING the device into Z-Wave network:
1.
Set controller into INCLUSION mode. Follow instructions provided by controller manufacturer.
2.
Press and hold any key on the panel for 8 seconds or 3 clicks in quick succession.
Note: If inclusion is successful, all INDICATION LEDs on the panel will flash 4 times.
EXCLUDING the device from Z-Wave network:
1.
Set controller into EXCLUSION mode. Follow instructions provided by controller manufacturer.
2.
Press and hold any key on the panel for 8 seconds or 3 clicks in quick succession.
Note: If the exclusion is successful, all INDICATION LEDs on the panel will flash 4 times. The
exclusion will delete all association data.
Turning on/off the device:
The device can be controlled by:
Pressing any key.
Sending commands through controller or gateway.
（
the command classes which support this
function are Basic Command Class, Binary Command Class, Switch All Command Class, and
Multi Channel Command Class.
）
Multi Channel Control:
The switch can be controlled by command “MULTI_CHANNEL_ENCAP” in the command
class “COMMAND_ CLASS_MULTI_CHANNEL”.
Refer to “Z-Wave Command Class
”
for detail information, or consult the information provided by
controller/ gateway manufacturer.
Byte
Name
1
COMMAND_CLASS_MULTI_CHANNEL
2
MULTI_CHANNEL_CMD_ENCAP
3
Source End Point
4
Destination End Point
5
COMMAND_CLASS_SWITCH_BASIC or COMMAND_CLASS_SWITCH_BINARY
6
BASIC_SET/BASIC_GET or BINARY_SET/BINARY_GET
7
Value ( 0xFF -- ON 0x0 -- OFF )
Multi Channel Association:
To set association groups by the command “COMMAND_CLASS_MULTI_CHANNEL_
ASSOCIATION”.
