06-10-2020 14
:
09
Pagina 2 van 5
http://manuals-backend.z-wave.info/make.php?lang=en&sku=MCOETPS412&cert=&type=mini
Connect Load wire to "L2"
1. Remove the steel frame from the device, and secure it onto the junctions box with tow screws.
2. Insert all wires into the right terminals and tighten screws.
3. Attach the wired device on "A" points of the steel frame as shown first, and then push the whole device into junction box.
4. Confirm the device is well mounted, power on and it is ready to operate.
Product Usage
The actuator is operated by the local switching Touch pannels or wirelessly using Z-Wave commands.
Scene Function:
1.
Scene Response Device
As a Scene Response device, it supports “Scene Activation CC” and “Scene Actuator Conf
CC” ,which make the device can be added into any scene , and supports 255 Scene ID. In parameter
item 0x10, users can configure which external switch button will respond the scene CC.
2.
Scene Activate Device
As a Scene Activate device, when pressing the switch button, it will send “Scene Activation” to
Association Group 1 (normally associated to the gateway) to activate corresponding scenes, and the
scene ID is set by configuration parameter. This function is disabled by default, to activate it, please
refer to the configuration parameter table item 17-19.
3.
Central Scene Activate Device
As a Central Scene Activate device, it supports “Central Scene CC”. When pressing the switch
button, it will send “Central Scene Notification” to Association Group 1 (normally associated to
gateway). This function is always being activated and cannot be disabled.
Reset to factory default
XXXResetDescription
Inclusion
To include the device you only need to press and hold any key for 8 seconds.
Exclusion
To exclude the device you only need to press and hold any key for 8 seconds.
NIF
XXXNIF
Wakeup
XXXWakeupDescription
Protection
XXXProtection
FirmwareUpdate
XXXFirmwareUpdate
SetAssociation
XXXSetAssociation
Association Groups:
Group Number
Maximum Nodes
Description
1
1
Lifeline
2
5
Associate with Key 1 - send Basic Set Command to associated devices
5
5
Associate with Key 2 - send Basic Set Command to associated devices
Configuration Parameters
Parameter 2: Switch state saved or not when power failure
Size: 1 Byte, Default Value: 1
