Part 2
1. Remove the front grille from the speaker to be installed. This is most easily
accomplished by rotating the six plastic mounting clips outward, pressing them towards
the front speaker frame. This will cause the screw heads, behind the grill, to push the
grill out from inside. In some cases, it may be necessary to gently pry the grill from the
front. This may be done with a small knife blade or micro size flat blade screwdriver. In
this case, extreme care should be taken not to damage the plastic frame around the grill.
2. Rotate the six mounting clips so they are flat against the side of the rear speaker
enclosure. If necessary, loosen the mounting screws, from the front of the speaker, to
allow these clips to rotate freely within their bracket.
3. Attach the speaker wire to the
( – )
and
( + )
connections on the rear of the enclosure.
Take care to observe correct polarity.
4. Fully insert the speaker into the wall and begin to tighten the mounting screws. Care
should be taken when tightening these screws. Make sure the screwdriver is secure in
the head of the screw and does not slip out and damage the speaker cone.
5. As screws are tightened, the plastic mounting clips will rotate clockwise and draw in
against the inside of the wallboard. If using a drill to tighten screws, tighten all six until
the speaker frame just makes contact with the wall. From there, it is best to use a hand
screwdriver to fully tighten. This will prevent breakage of the plastic mounting clips.
6. In an alternating cross pattern, (center left, center right, top left, bottom right, top right,
bottom left) tighten all six screws, by hand, until the speaker frame is snug against the
wall. Take care not to over-tighten as this may damage the mounting clips or the
mounting frame.
7. Once all screws are tightened, the grill may be reinstalled on the front of the speaker.
8. The other end of the speaker wire is now ready for connection to the sound source
Warranty
MCM Custom Audio products are warranted against manufacturer defects for a period of 12
months from the original date of purchase. This warranty is limited to manufacturer defects, in
either materials or workmanship. MCM an InOne company, or any other worldwide divisions of
Premier Farnell PLC, are not responsible for any consequential or inconsequential damage to any
other component, structure or the cost of installation or removal of said items.
This warranty will not cover damage due to improper use such as (an not limited to) damaged
cones, mounting frames, voice coils or items damaged by whether damaged items.
For questions or specific information regarding warranty replacement or repair, contact:
MCM, an InOne company
www.mcminone.com
800-543-4330
