6
Infrared Tympanic Electronic Thermometer
Pulse Timer Mode
1.
Press and hold the timer button to enter Timer mode. Press again to start the timer. The timer will
run from 0 to 60 seconds.
2.
The thermometer will issue a single beep at 15 seconds, a dual beep at 30 seconds, a triple beep at 45
seconds, and four beeps at 60 seconds.
3.
Press the timer button at any point during the timer function to return the thermometer to “off“ mode.
4.
At the end of the 60 seconds, the thermometer will wait two seconds and then enter sleep mode.
5.
Return the thermometer to base for storage.
Thermometer Display Icons and Alarms
Thermometer operation is communicated to the user via the LCD display and an audible device contained inside
the thermometer case. After the probe cover is installed or the batteries have been changed, the thermometer will
perform a system reset. The thermometer will perform an internal test to verify that the system components are
functioning properly.
Alarm Condition
Display Mode
˚C
EAR
Patient temperature above specified range
Patient temperature below specified range
Ambient Temperature above specified range
Ambient Temperature below specified range
Low Battery
Dead Battery
˚C
EAR
EAR
EAR
˚C
EAR
The LCD displays the low battery icon. The low battery icon will remain on
until the battery is replaced or until the dead battery icon is displayed. After
the low battery icon is displayed, the user may take approximately 100
temperatures until the dead battery icon is displayed.
The LCD displays the dead battery condition. When any button is pressed, the
battery icon will flash several times and then the LCD will turn OFF. After the
battery icon is displayed, the batteries must be changed before the thermometer
can be used.