background image

11

Quantity  Part Number 

Description

 1 

033838 

Shipping carton only

 2 

033837 

End cap 

 1 

033836 

Inside carton only

 1 

033725 

Top pad

 1 

034576 

Bottom pad

 1 

034592 

Filler pad

 2 

034446 

Foam plug

 4 

017937 

Plastic foot

 4 

400159 

#10-32 x 3/4” screw

 4 

404080 

#10 Flat washer

FOAM PLUG

IMPORTANT

See 

Note 

under Packing Instruc�ons

Packing Instructions 

In the event it is necessary to repack the equipment for 

shipment, the equipment must be packed exactly as 

shown below. 

Note: 

 It is very important that the four plastic feet are  

attached to the bottom of the equipment. This will  

ensure the proper equipment location on the bottom 

pad. Failure to do this will result in shipping damage.

Use the original shipping carton and interior parts 

only if they are all in good serviceable condition.  

If a shipping carton or any of the interior part(s) are 

needed, please call or write Customer Service Depart-

ment of McIntosh Laboratory.

Specifications

Power Output 

Minimum sine wave continuous average power output 

per channel, all channels operating is: 

50 watts into a 8 ohm load 

90 watts into a 4 ohm ohm load

Output Load Impedance 

8 and 4 ohms 

Rated Power Band 

20Hz to 20,000Hz

Total Harmonic Distortion 

0.05% maximum harmonic distortion at any power 

level from 250 milliwatts to rated power, 20Hz to 

20,000Hz

Dynamic Headroom 

2.1dB, 8 ohm load 

3.3dB, 4 ohm load

Frequency Response 

+0, -0.5dB from 20Hz to 20,000Hz

Input Sensitivity (for rated output) 

1.6 Volt Unbalanced (8 ohm Loudspeaker) 

1.3 Volt Unbalanced (4 ohm Loudspeaker)

Signal To Noise Ratio (A-Weighted) 

85dB (95dB below rated output)

Intermodulation Distortion 

0.2% maximum, if the instantaneous peak power output 

does not exceed twice the rated power output or less per 

channel with all channels operating for any combina-

tion of frequencies from 20Hz to 20,000Hz

Wide Band Damping Factor 

Greater than 65, at 8 ohms 

Greater than 32, at 4 ohms

Input Impedance 

26,000 ohms Unbalanced

Voltage Gain 

29dB

Power Control Input 

5-15VDC, less than 1mA

Power Control Output 

12VDC, 50mA maximum total

Power Requirements 

100 - 240Volts, 50/60Hz at 10 Amps 

Standby: less than 0.5 watt

Overall Dimensions 

Width is 17-1/2 inches (44.5cm) 

Width with Side Mount Brackets attached is 19 inches 

(48.3cm) 

Height is 4-5/16 inches (11.0cm) including feet
Depth is 21 inches (53.3cm) including the Front Panel 

and Cables

Weight 

22 pounds (10 kg) net, 38.4 pounds, 

(17.4 kg) in shipping carton

Shipping Carton Dimensions 

Width is 26-1/2 inches (67.3cm) 

Height is 11-3/4 inches (29.9cm) 

Depth is 24-1/4 inches (61.6cm)

Содержание MI1250













Отзывы: