McIntosh MCD7008, Руководство пользователя

Страница: 16 / 24

Connect a cable from the MCD7008 DATA IN jack to the DATA OUT jack on the other instru-
ment being used. This allows the HR 7008 Remote Controller to transmit directly to the Mclntosh
oreamplifier or Remote Control System sensors, and all player functions can be performed.
CONDITIONS AND SOLUTIONS
The letters ERR appear on the display panel and the player will not function.
On very rare occasions the system control may lock up or freeze operation. To reset the system
control, simply turn the player main power OFF for a few seconds and then back ON. If this
condition should continue to occur, contact your authorized Mclntosh dealer or service organization
for assistance.
The disc tray will not open.
Make sure the player locking screw, accessible from the bottom panel, is set to the FREE
position.
You are unable to playback any discs.
Be sure all the discs are clean and with no fingerprints. Clean the discs with a soft dry cloth,
gently wiping from the center of the disc to the outer edge. Do not rub in a circular motion.
If a disc has had a stabilizer installed, remove the stabilizer.
If two discs have accidentally been stacked in a single tray, remove the second disc.
If a disc is inserted upside down, remove it and reinstall it with the label side UP
It is possible in some environments for moisture to condense on the laser lens. Turn the player
on in the standby mode for at least 30 minutes to one hour, and then start operation.
Sound is uneven or the player mistracks the disc.
The Disc surface may be dirty. Clean the discs in the manner described above.
If a problem in playback occurs at the same point in a given disc, the disc may be scratched,
damaged or defective. You may skip to the next track, or replace the disc.
A disc stabilizer may be on the disc. Remove the stabilizer.
Two discs may be stacked in the same tray. Remove the second disc.
Check the condition of all equipment interconnections and their cables. Make sure all cable
connectors are firmly and fully installed into their respective jacks.
Hum is present in the playback sound.
Check the condition of all interconnecting cables. Make sure all cable connectors are firmly
and fully installed in their respective jacks.
15
HOW TO PLAYBACK
USING THE HR7008
CONTROLLER
TRANSMITTING
DIRECTLY TO A
MclNTOSH
PREAMPLIFIER,
RECEIVER OR
REMOTE CONTROL
SYSTEM SENSOR
USING THE DATA
JACKS
IF YOU
NEED HELP