11
Note: Refer to “Output Terminal” step 4 on
page 10 for important information.
If the Loudspeaker’s impedance is in-between
the available connections, use the nearest lower
impedance connection. Refer to “General
Information” Note 6 on page 6 for additional
information.
WARNING: Loudspeaker terminals are hazardous
live and present a risk of electric
shock. For additional instruction on
making Loudspeaker Connections
contact your McIntosh Dealer or
McIntosh Technical Support.
9. Connect the MC1502 Power Cord to an active AC
outlet.
are indentified as 4Ω (ohms), 8Ω (ohms) or 16Ω
(ohms) connection to match the impedance of the
Loudspeaker, being careful to observe the correct
polarities.
If the Loudspeaker’s impedance is in-between
the available connections, use the nearest lower
impedance connection. Refer to “General
Information” Note 6 on page 6 for additional
information.
WARNING: Loudspeaker Terminals are hazardous
live and present a risk of electric shock.
For additional instruction on making
Loudspeaker Connections contact
your McIntosh Dealer or McIntosh
Technical Support.
7. Connect the MC1502 Power Cord to an active AC
outlet.
Spade Lug or Wire Connections:
8. Connect the Loudspeaker hookup cables to the
MC1502 Negative Output Terminal (-) and Positive
Output (+) Terminal indentified as 2Ω (ohms),
4Ω (ohms) or 8Ω (ohms) connection to match the
impedance of the Loudspeaker, being careful to
observe the correct polarities. Insert the spade
lug connector or prepared section of the cable end
into the terminal side access hole, and tighten the
terminal cap until the cable is firmly clamped into
the terminals so the lugs or wire cannot slip out.
Do
not over tighten.
Refer to figures 4, 5 and figure E.
How to Connect for Operation
Figure 4
Figure 5
