McIntosh MA 230 - SERVICS BULLETINS, Руководство пользователя

Страница: 12 / 24

4. Cut out the rectangular opening.
5. Secure the mounting strips to the in-
side of the panel.
In the hardware package are 4 flat head
screws and 8 fillister head screws. Two of the
flat head screws of the proper length are
used to attach the mounting strips to the
cabinet panel. Four of the fillister head
screws are used to attach the MA230 mount-
ing brackets to the cabinet panel and the
mounting strips behind the panel. The ¼ inch
screws are used for panel thickness less than
3
/
8
inch. The 1¼ inch screws are used with
panels from
3
/
8
inch to 1 inch in thickness.
Insert the proper length flat head screw
through the center " B " holes of the cabinet
panel ("B" holes marked on mounting tem-
plate). Position the mounting strip behind
the cabinet panel. The edge of the mounting
strip that has the clips must be facing the
rectangular cutout. Align the three holes in
the mounting strip with the holes in the cabi-
net panel.
Tighten the flat head screw so that the
screw head pulls in the wood panel level with
the panel surface. Repeat this with the sec-
ond mounting strip on the other side of the
rectangular cutout.
6. Left and right metal mounting brackets
are packed with the MA230. Fasten these two
mounting brackets to the cabinet panel using
four of the fillister head screws. These screws
should pass through the mounting shelf
flange, through the cabinet panel and then
into the mounting strip attached to the inside
of the panel. Tighten the screws firmly, but
do not over-tighten.
7. Prepare the MA230 for mounting by
removing the four plastic feet fastened under
the chassis.
8. The MA230 is installed from the FRONT
of the cabinet. Insert the MA230 power cord
through the rectangular opening of the cabi-
net panel. Carefully slide the MA230 into the
opening so the plastic rails on the bottom of
the chassis engage the grooves in the metal
mounting brackets. Slide the MA230 in until
its front panel is against the cabinet mount-
ing panel.
9. Secure the MA230 to the mounting
brackets by inserting the two knurled screws
into the back of the MA230 chassis, through
the back flanges of the mounting brackets.
Figure 21. Mounting Brackets installed in cabinet panel.
Figure 22. Securing MA230 to Mounting Brackets.
10
Figure 20. Securing Mounting Strips
to Installation Cutout.
Figure 19. Installation Cutout.